ASTM C1002-22 - 1.6.2022
 
1. Scope

1.1?This specification covers steel self-piercing tapping screws for use in fastening gypsum panel products and metal plaster bases to cold-formed steel studs less than 0.033 in. (0.84 mm) in thickness and wood members, and for fastening gypsum panel products to gypsum board.

1.2?This specification also covers test methods for determining performance requirements and physical properties.

1.3?The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4?The following safety hazards caveat pertains only to the test methods described in this specification:

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

 
2. Referenced Documents

A548-

Withdrawn 1989: Specification for Steel Wire, Carbon, Cold-Heading Quality, for Tapping or Sheet Metal Screws

A568/A568M-19a

Standard Specification for Steel, Sheet, Carbon, Structural, and High-Strength, Low-Alloy, Hot-Rolled and Cold-Rolled, General Requirements for (Includes all amendments and changes 11/22/2019).

C11-23

Standard Terminology Relating to Gypsum and Related Building Materials and Systems

C847-18

Standard Specification for Metal Lath

C1396/C1396M-17

Standard Specification for Gypsum Board

C645-18

Standard Specification for Nonstructural Steel Framing Members