Plastics pipes and fittings Peel decohesion test for polyethylene(PE)electrofusion assemblies of nominal outside diameter greater than or equal to 90 mm

Standard published on 23.3.2005

Plastics pipes and fittings-Preparation of polyethylene(PE)pipe/pipe or pipe/fitting test piece assemblies by butt fusion

Standard published on 23.3.2005

Varnishes used for electrical insulation - Part 1: Definitions and general requirements

Standard published on 3.12.2007

Varnishes used for electrical insulation - Part 2: Methods of test

Standard published on 10.6.2009

Varnishes used for electrical insulation - Part 3: Specifications for hot curing impregnating varnishes

Standard published on 10.6.2009

Varnishes used for electrical insulation - Part 4: Polyester-imide varnishes

Standard published on 10.6.2009

Varnishes used for electrical insulation - Part 5: Energy-saving fast curing melamine alkyd impregnating varnishes

Standard published on 10.6.2009

Varnishes used for electrical insulationPart 6Environment-friendly water or emulsion based impregnating varnishes

Standard published on 24.7.2014

Polyethylene(PE)pipe and fittings-Determination of the tensile strength and failure mode of test pieces from a butt-fused joint

Standard published on 23.3.2005

Plastics-Determination of the degree of disintegration of plastic materials under defined composting conditions in a pilot-scale test

Standard published on 23.3.2005