Standards ČSN - Czech national standards - Page 1321

Test conditions for numerically controlled turning machines and turning centres - Part 3: Geometric tests for machines with inverted vertical workholding spindles

Standard published on 1.9.2014

Test conditions for numerically controlled turning machines and turning centres - Part 4: Accuracy and repeatability of positioning of linear and rotary axes

Standard published on 1.6.2005

Test conditions for numerically controlled turning machines and turning centres - Part 5: Accuracy of speeds and interpolations

Standard published on 1.1.2020

Test conditions for numerically controlled turning machines and turning centres - Part 6: Accuracy of a finished test piece

Standard published on 1.9.2014

Test conditions for numerically controlled turning machines and turning centres - Part 7: Evaluation of contouring performnce in the coordinate planes

Standard published on 1.6.2005

Test conditions for numerically controlled turning machines and turning centres - Part 8: Evaluation of thermal distortions

Standard published on 1.6.2005

Test conditions for numerically controlled turning machines and turning centres - Part 1: Geometric tests for machines with horizontal workholding spindle

WITHDRAWN published on 1.7.2005

Test conditions for numerically controlled turning machines and turning centres - Part 2: Geometric tests machines with a vertical workholding spindle

WITHDRAWN published on 1.1.2020

Acceptance conditions for vertical turning and boring lathes with one or two columns and a single fixed or movable table. General introduction and testing of the accuracy

Standard published on 10.5.1991

WITHDRAWN published on 19.9.1957