Standards ČSN - Czech national standards - Page 1555

Geometrical Product Specifications (GPS) - Acceptance and reverification tests for coordinate measuring machines (CMM) - Part 4: CMMs used in scanning measuring mode

WITHDRAWN published on 1.9.2001

Geometrical Product Specifications (GPS) - Acceptance and reverification tests for coordinate measuring machines (CMM) - Part 5: CMMs using multiple-stylus probing systems

WITHDRAWN published on 1.1.2002

Geometrical product specifications (GPS) - Acceptance and reverification tests for coordinate measuring machines (CMM) - Part 5: CMMs using single and multiple stylus contacting probing system

WITHDRAWN published on 1.5.2011

Geometrical product specifications (GPS) - Acceptance and reverification tests for coordinate measuring systems (CMS) - Part 9: CMMs with multiple probing systems

WITHDRAWN published on 1.8.2014

Geometrical product specifications (GPS) - Acceptance and reverification tests for coordinate measuring systems (CMS) - Part 10: Laser trackers for measuring point-to- point distances

WITHDRAWN published on 1.10.2016

Klasifikace přístrojů a zařízení na měření a hodnocení geometrických parametrů stavu povrchu.

WITHDRAWN published on 1.11.1993

WITHDRAWN published on 21.12.1972

WITHDRAWN published on 15.2.1980

Roughness comparison specimens. Part 1: Turned, ground, bored, milled, shaped and planed

WITHDRAWN published on 1.8.1994

Roughness comparison spacimens. Part 2: Spark-eroded, shot-blasted and grit-blasted and polished

WITHDRAWN published on 1.8.1994