Standards ČSN - Czech national standards - Page 5573

Plastics piping systems - Polyethylene (PE) valves - Test method for resistance to bending between supports

Standard published on 1.8.2025

Plastics piping systems - Polyethylene (PE) valves - Test method for resistance to bending between supports

WITHDRAWN published on 1.9.1998

Plastics piping systems - Polyethylene (PE), crosslinked polyethylene (PE-X) and unplasticized polyamide (PA-U) pipes - Test method for the resistance to internal pressure after application of squeeze-off

Standard published on 1.10.2025

Plastics piping systems - Polyethylene (PE) pipes - Test method for the resistance to internal pressure after application of squeze-off

WITHDRAWN published on 1.9.1998

Plastics piping systems - Fittings, valves and ancillaries - Determination of gaseous flow rate/pressure drop relationships

Standard published on 1.10.2015

Plastics piping systems - Fittings, valves and ancillaries - Determination of gaseous flow rate/pressure drop relationships

WITHDRAWN published on 1.9.1998

Plastics piping systems - Determination of moisture content in thermoplastics by coulometry

WITHDRAWN published on 1.9.1998

Plastic piping systems - Injection-moulded thermoplastics fittings, valves and ancillary equipment - Determination of the long-term hydrostatic strength of thermoplastics materials for injection moulding of piping components

WITHDRAWN published on 1.10.1998

Plastics piping systems for water supply or drainage and sewerage - Glass-reinforced thermosetting plastics (GRP) based on unsaturated polyester resin (UP) - Recommended practice for installation

Standard published on 1.6.2014

Plastics piping systems for water supply or drainage and sewerage - Glass-reinforced thermosetting plastics (GPR) based on unsaturated polyester resin (UP) - Recommended practice for installation

WITHDRAWN published on 1.3.2005