Radio-frequency connectors - Part 1-4: Electrical test methods - Voltage standing wave ratio, return loss and reflection coefficient
(Connecteurs pour frequences radioelectriques - Partie 1-4 : Methodes d’essai electriques - Rapport d’ondes stationnaires en tension, affaiblissement de reflexion et coefficient de reflexion)

Standard published on 8.7.2020

Radio frequency connectors - Part 1-5: Electrical test methods - Rise time degradation
(Connecteurs pour frequences radioelectriques - Partie 1-5: Methodes d’essai electrique - Degradation du temps de montee)

Standard published on 3.2.2022

Radio frequency connectors - Part 1-51: Technical specification of electrical tests - Uncertainty specification of frequency domain test for return loss

Standard published on 20.10.2020

Radio-frequency connectors - Part 1-6: Electrical test methods - RF power
(Connecteurs pour frequences radioelectriques - Partie 1-6: Methodes d’essai electrique - Puissance RF)

Standard published on 18.2.2022

Radio-frequency connectors - Part 1-7: Electrical test methods - Uncertainty specification of frequency domain test for insertion loss

Standard published on 27.8.2025

Radio-frequency connectors - Part 1-8: Electrical test methods - Voltage standing wave ratio for a single connector by double connector method

Standard published on 17.12.2025

Radio-frequency connectors – Part 1-9: Mechanical test methods – Safety wire hole pull-out
(Connecteurs pour frequences radioelectriques – Partie 1-9: Methodes d’essais mecaniques – Extraction par le trou du fil de securite)

Standard published on 14.5.2025

Radio frequency connectors - Part 1: Generic specification - General requirements and measuring methods
(Connecteurs pour frequences radioelectriques - Partie 1: Specification generique - Exigences generales et methodes de mesure)

Standard published on 10.7.2013

Corrigendum 1 - Radio frequency connectors - Part 1: Generic specification - General requirements and measuring methods

Correction published on 10.2.2016

Radio-frequency connectors - Part 10: Sectional specification for RF coaxial connectors with inner diameter of outer conductor 3 mm (0,12 in) with snap-on coupling - Characteristic impedance 50 ohm (Type SMB)
(Connecteurs pour frequences radioelectriques - Partie 10: Specification intermediaire relative aux connecteurs coaxiaux pour frequences radioelectriques avec diametre interieur du conducteur exterieur de 3 mm (0,12 in) a couplage par encliquetage - Impedance caracteristique 50 ohm (type SMB))

Standard published on 22.2.2024