Standards ISO - International Organization for Standardization - Page 2330

Dentistry — Laboratory cutters — Part 1: Steel laboratory cutters
(Médecine bucco-dentaire — Fraises de laboratoire — Partie 1: Fraises de laboratoire en acier)

Standard published on 29.4.2016

Dentistry — Laboratory cutters — Part 2: Carbide laboratory cutters
(Médecine bucco-dentaire — Fraises de laboratoire — Partie 2: Fraises de laboratoire en carbure)

Standard published on 2.3.2020

Dentistry — Laboratory cutters — Part 3: Carbide cutters for milling machines
(Médecine bucco-dentaire — Fraises de laboratoire — Partie 3: Fraises de laboratoire en carbure pour machines a fraiser)

Standard published on 3.5.2017

Dental rotary instruments — Cutters — Part 4: Miniature carbide laboratory cutters
(Instruments rotatifs dentaires — Fraises techniques — Partie 4: Fraises techniques miniatures en carbure pour laboratoire)

Standard published on 14.3.2002

Steel — Surface finish of hot-rolled plates and wide flats — Delivery requirements
(Acier — État de surface des tôles et larges-plats laminés a chaud — Conditions de livraison)

Standard published on 15.10.2021

Hydraulic fluid power — Two-, three- and four-port screw-in cartridge valves — Cavities
(Transmissions hydrauliques — Distributeurs a cartouche a visser a deux, trois et quatre orifices — Logements)

Standard published on 1.10.2007

Hydraulic fluid power — Four-port modular stack valves and four-port directional control valves, sizes 02, 03, 05, 07, 08 and 10 — Clamping dimensions
(Transmissions hydrauliques — Appareils empilables et distributeurs a quatre orifices, de tailles 02, 03, 05, 07, 08 et 10 — Dimensions de montage)

Standard published on 26.2.2013

Cross-country skis — Ski-binding screws — Requirements
(Skis de fond — Vis de fixation — Exigences)

Standard published on 5.5.2011

Cross-country skis — Ski-binding screws — Test methods
(Skis de fond — Vis de fixation — Méthodes d´essai)

Standard published on 2.8.2011

Skis — Geometry — Measuring conditions
(Skis — Géométrie — Conditions de mesurage)

Standard published on 26.9.1985