Standards JIS - Japanese technical standards - Page 778

Plastics -- Injection moulding of test specimens of thermoplastic materials -- Part 3: Small plates

Standard published on 20.2.2006

Plastics -- Injection moulding of test specimens of thermoplastic materials -- Part 4: Determination of moulding shrinkage

Standard published on 20.2.2006

Plastics -- Injection moulding of test specimens of thermoplastic materials -- Part 5: Preparation of standard specimens for investigating anisotropy

Standard published on 20.7.2007

Plastics -- Determination of linear dimensions of test specimens

Standard published on 20.12.2008

Plastics -- Injection moulding of test specimens of thermosetting powder moulding compounds (PMCs) -- Part 1: General principles and moulding of multipurpose test specimens

Standard published on 31.7.2002

Plastics -- Injection moulding of test specimens of thermosetting powder moulding compounds (PMCs) -- Part 2: Small plates

Standard published on 31.7.2002

Plastics -- Determination of tensile-impact strength

Standard published on 31.3.1996

Plastics -- Determination of tensile properties -- Part 2: Test conditions for moulding and extrusion plastics

Standard published on 22.9.2014

Plastics -- Determination of tensile properties -- Part 4: Test conditions for isotropic and orthotropic fibre-reinforced plastic composites

Standard published on 20.12.2005

Plastics -- Determination of tensile properties -- Part 5: Test conditions for unidirectional fibre-reinforced plastic composites

Standard published on 20.3.2008