Standards UNE - Spanish national standards - Page 5899

INSULATING AND SHEATHING MATERIALS OF ELECTRIC CABLES. COMMON TEST METHODS. PART 4: METHODS SPECIFIC TO POLYETHYLENE AND POLYPROPYLENE COMPOUNDS. SECTION 1: RESISTANCE TO ENVIRONMENTAL STRESS CRACKING. WRAPPING TEST AFTER THERMAL AGEING IN AIR. MEASUREMENT OF THE MELT FLOW INDEX. CARBON BLACK AND/OR MINERAL CONTENT MEASUREMENT IN PE.

WITHDRAWN published on 22.4.1996

Insulating and sheathing materials of electric and optical cables - Common test methods -- Part 4-1: Methods specific to polyethylene and polypropylene compounds - Resistance to environmental stress cracking - Measurement of the melt flow index - Carbon black and/or mineral filler content measurement in polyethylene by direct combustion - Measurement of carbon black content by termogravimetric analysis (TGA) - Assessment of carbon black dispersion in polyethylene using a microscope

WITHDRAWN published on 5.10.2005

Insulating and sheathing materials of electric and optical fibre cables - Common test methods -- Part 4: Methods specific to polyethylene and polypropylene compounds -- Section 2: Tensile strength and elongation at break after pre-conditioning - Wrapping test after thermal ageing in air - Measurement of mass increase - Long-term stability test - Test method for copper-catalysed oxidative degradation

WITHDRAWN published on 14.6.2000

Insulating and sheathing materials of electric and optical cables - Common test methods -- Part 4-2: Methods specific to polyethylene and polypropylene compounds - Tensile strength and elongation at break after conditioning at elevated temperature - Wrapping test after conditioning at elevated temperature - Wrapping test after thermal ageing in air - Measurement of mass increase - Long-term stability test - Test method for copper-catalyzed oxidative degradation

WITHDRAWN published on 5.10.2005

INSULATING AND SHEATHING MATERIALS OF ELECTRIC AND OPTICAL CABLES. COMMON TEST METHODS. PART 5-1: METHODS SPECIFIC TO FILLING COMPOUNDS. DROPT POINT. SEPARATION OF OIL. LOW TEMPERATURE BRITTLENESS. TOTAL ACID NUMBER. ABSENCE OF CORROSIVE COMPONENTS. PERMITTIVITY AT 23 oC. DC RESISTIVITY AT 23 oC AND 100 oC.

WITHDRAWN published on 22.9.1999

Analysis techniques for system reliability - Procedure for failure mode and effects analysis (FMEA) (IEC 60812:2006). (Endorsed by AENOR in May of 2007.)

WITHDRAWN published on 10.10.2013

Analysis techniques for system reliability - Procedure for failure mode and effects analysis (FMEA)

WITHDRAWN published on 30.12.2008

NON-CELLULOSIC PAPERS FOR ELECTRICAL PURPOSES. PART 1: DEFINITIONS AND GENERAL REQUIREMENTS.

WITHDRAWN published on 24.7.1996

Non-cellulosic papers for electrical purposes -- Part 3: Specifications for individual materials -- Sheet 3: Unfilled aramid (aromatic polyamide) papers (IEC 60819-3-3:2006) (Endorsed by AENOR in November of 2006.)

WITHDRAWN published on 18.10.2014

Non-cellulosic papers for electrical purposes - Part 3: Specifications for individual materials - Sheet 4: Aramid fibre paper containing not more than 50 % of mica particles

WITHDRAWN published on 30.5.2002