Standards UNE - Spanish national standards - Page 642

Metallic materials - Instrumented indentation test for hardness and materials parameters - Part 1: Test method (ISO 14577-1:2015)

Standard published on 13.1.2016

Metallic materials - Instrumented indentation test for hardness and materials parameters - Part 2: Verification and calibration of testing machines (ISO 14577-2:2015)

Standard published on 13.1.2016

Metallic materials - Instrumented indentation test for hardness and materials parameters - Part 3: Calibration of reference blocks (ISO 14577-3:2015)

Standard published on 13.1.2016

Metallic materials - Instrumented indentation test for hardness and materials parameters - Part 4: Test method for metallic and non-metallic coatings (ISO 14577-4:2016)

Standard published on 19.7.2017

Materials and articles in contact with foodstuffs - Plastics - Polymeric additives - Test method for the determination of the mass fraction of a polymeric additive that lies below 1 000 Daltons

Standard published on 13.7.2005

Plastics piping systems for water supply or drainage and sewerage - Glass-reinforced thermosetting plastics (GRP) based on unsaturated polyester resin (UP) - Recommended practice for installation (Endorsed by AENOR in May of 2014.)

Standard published on 1.5.2014

Natural stone test methods - Determination of sound speed propagation

Standard published on 6.7.2005

Hexalobular socket head cap screws (ISO 14579:2011)

Standard published on 23.11.2011

Domestic direct gas-fired tumble dryers of types B22D and B23D, of nominal heat input not exceeding 6 kW - Part 1: Safety

Standard published on 5.9.2012

Domestic direct gas-fired tumble dryers of types B22D and B23D, of nominal heat input not exceeding 6 kW - Part 2: Rational use of energy

Standard published on 25.7.2012