Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM A1044/A1044M-15
Standard Specification for Steel Stud Assemblies for Shear Reinforcement of Concrete
STANDARD published on 1.3.2015
The information about the standard:
Designation standards: ASTM A1044/A1044M-15
Note: WITHDRAWN
Publication date standards: 1.3.2015
SKU: NS-585693
The number of pages: 5
Approximate weight : 15 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM A1044/A1044M-15 :
Keywords:
base rail, concrete reinforcement, headed studs, shear reinforcement, steel, stud assemblies,, ICS Number Code 91.080.40 (Concrete structures)
Additional information
| 1. Scope | ||||||||||||||||||
|
1.1 This specification covers steel stud assemblies for shear reinforcement of concrete. Stud assemblies consist of either single-headed studs attached to a steel base rail by welding, or double-headed studs mechanically crimped into a steel shape. Note 1: The configuration of the studs for stud assemblies is
much different than the configuration of the headed-type studs
prescribed in Section 7, Figure 7.1 of AWS D1.1/D1.1M. Ratios of
the cross-sectional areas of the head-to-shank of the AWS
D1.1/D1.1M studs range from about 2.5 to 4. In contrast, this
specification requires the area of the head of the studs for stud
assemblies to be at least 10 times the area of the shank. Thus, the
standard headed-type studs in Section 7, Figure 7.1 of AWS
D1.1/D1.1M do not conform to the requirements of this specification
for use as stud assemblies for shear reinforcement.
1.2 This specification is applicable for orders in either inch-pound units or in SI units. 1.3 The values stated either in inch-pound or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with this specification. |
||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
