Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM A20/A20M-06
Standard Specification for General Requirements for Steel Plates for Pressure Vessels
STANDARD published on 1.10.2006
The information about the standard:
Designation standards: ASTM A20/A20M-06
Note: WITHDRAWN
Publication date standards: 1.10.2006
SKU: NS-1559
The number of pages: 33
Approximate weight : 99 g (0.22 lbs)
Country: American technical standard
Category: Technical standards ASTM
Annotation of standard text ASTM A20/A20M-06 :
Keywords:
general delivery requirement, pressure containing parts, pressure vessel steels, steel plates, steel plates for pressure vessel applications, ICS Number Code 23.020.30 (Pressure vessels, gas cylinders), 77.140.50 (Flat steel products and semi-products)
Additional information
| 1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
1.1 This general requirements specification covers a group of common requirements that, unless otherwise specified in the applicable product specification, apply to rolled steel plates for pressure vessels covered by each of the following product specifications issued by ASTM: 1.1.1 This general requirements specification also covers a group of supplementary requirements that are applicable to several of the above product specifications as indicated therein. Such requirements are provided for use if additional testing or additional restrictions are required by the purchaser, and apply only if specified individually in the purchase order. 1.2 Appendix X1 provides information on coil as a source of plates for pressure vessels. 1.3 Appendix X2 provides information on the variability of tensile properties in plates for pressure vessels. 1.4 Appendix X3 provides information on the variability of Charpy-V-Notch impact test properties in plates for pressure vessels. 1.5 Appendix X4 provides information on cold bending of plates, including suggested minimum inside radii for cold bending. 1.6 These materials are intended to be suitable for fusion welding. When the steel is to be welded, it is presupposed that a welding procedure suitable for the grade of steel and intended use or service will be utilized. 1.7 In case of any conflict in requirements, the requirements of the applicable product specification prevail over those of this general requirements specification. 1.8 Additional requirements that are specified in the purchase order and accepted by the supplier are permitted, provided that such requirements do not negate any of the requirements of this general requirements specification or the applicable product specification. 1.9 For purposes of determining conformance with this general requirements specification and the applicable product specification, values are to be rounded to the nearest unit in the right-hand place of figures used in expressing the limiting values in accordance with the rounding method of Practice E 29. 1.10 The values stated in either inch-pound units or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents. Therefore, each system is to be used independently of the other. 1.11 This general requirements specification and the applicable product specification are expressed in both inch-pound units and SI units; unless the order specifies the applicable "M" specification designation (SI units), the plates are to be furnished to inch-pound units. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
We recommend:
Updating of laws
Do you want to be sure about the validity of used regulations?
We offer you a solution so that you could use valid and updated legislative regulations.
Would you like to get more information? Look at this page.
