We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
Standard Specification for Copper-Brazed Steel Tubing
Translate name
STANDARD published on 1.9.2019
Designation standards: ASTM A254/A254M-12(2019)
Publication date standards: 1.9.2019
SKU: NS-970171
The number of pages: 4
Approximate weight : 12 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
This specification covers double-wall, copper brazed steel tubing suitable for general engineering uses, particularly in the automotive, refrigeration, and stove industries for fuel lines, brake lines, oil lines, heating and cooling units, and the like. The tubing shall be made by rolling steel strip into the form of tubing and subsequently copper brazing in a reducing atmosphere. The steel shall conform to the prescribed chemical composition and shall be subjected to heat analysis and product analysis. Tension, flattening, expansion, bending, and pressure proof tests shall be made in accordance with the specification.
Keywords:
steel tube ,, ICS Number Code 23.040.15 (Non-ferrous metal pipes)
1. Scope | ||||||||||
1.1 This specification covers double-wall, copper-brazed steel tubing suitable for general engineering uses, particularly in the automotive, refrigeration, and stove industries for fuel lines, brake lines, oil lines, heating and cooling units, and the like. The tubing is available in either of two types, single strip or double strip as shown in Fig. 1. FIG. 1 Brazed Tubing, Double-Wall, 360-deg Brazed Construction 1.2 Units—This specification is expressed in both inch-pounds units and in SI units; however, unless the purchase order or contract specifies the applicable M specification designation (SI units), the inch-pound units shall apply. The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. In this specification hard or rationalized conversions apply to diameters, lengths, and tensile properties. Soft conversion applies to other SI measurements. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||
2. Referenced Documents | ||||||||||
|
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
Latest update: 2024-04-18 (Number of items: 2 859 866)
© Copyright 2024 NORMSERVIS s.r.o.