Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM A325M-04b
Standard Specification for Structural Bolts, Steel, Heat Treated 830 MPa Minimum Tensile Strength [Metric] (Includes all amendments And changes 8/16/2017).
Automatically translated name:
Standard Specification for Structural Bolts, Steel, Heat Treated 830 MPa Minimum Tensile Strength [Metric]
STANDARD published on 1.9.2004
The information about the standard:
Designation standards: ASTM A325M-04b
Note: WITHDRAWN
Publication date standards: 1.9.2004
SKU: NS-2062
The number of pages: 7
Approximate weight : 21 g (0.05 lbs)
Country: American technical standard
Category: Technical standards ASTM
Annotation of standard text ASTM A325M-04b :
Keywords:
alloy steel, bolts, carbon steel, metric, steel, structural, weathering steel, ICS Number Code 21.060.10 (Bolts, screws, studs)
Additional information
| 1. Scope | ||||||||||||||||||||||||||||||||||||
|
1.1 This specification covers two types of quenched and tempered, steel, metric heavy hex structural bolts having a minimum tensile strength of 830 MPa (Note 1). 1.2 The bolts are intended for use in structural connections. These connections are comparable to those covered under the requirements of the Specification for Structural Joints using ASTM A 325 or A 490 bolts, approved by the Research Council on Structural Connections; endorsed by the American Institute of Steel Construction and by the Industrial Fastener Institute. 1.3 The bolts are furnished in sizes M12 to M136 inclusive. They are designated by type denoting chemical composition as follows: 1.3.1 Type 1—Medium-carbon, carbon boron, medium carbon alloy, or alloy boron steel. 1.3.2 Type 2—Withdrawn in 2003. 1.3.3 Type 3—Weathering Steel. 1.4 This specification is applicable to metric heavy hex, structural bolts only. 1.5 Terms used in this specification are defined in Specification F 1789. 1.6 The following safety hazards caveat pertains only to the test methods portion, Section 10, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use. Note 1—This specification is the metric companion to the inch pound Specification A 325. |
||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
