Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM A334/A334M-99
Standard Specification for Seamless and Welded Carbon and Alloy-Steel Tubes for Low-Temperature Service
STANDARD published on 10.1.1999
The information about the standard:
Designation standards: ASTM A334/A334M-99
Note: WITHDRAWN
Publication date standards: 10.1.1999
SKU: NS-2093
The number of pages: 5
Approximate weight : 15 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
Annotation of standard text ASTM A334/A334M-99 :
Keywords:
Alloy steel tube, Carbon steel tube, Low temperature service applications, emsteel, Welded steel tube, tubes, emcarbon/alloy steel, seamless/welded (for low-temperature, ICS Number Code 23.040.10 (Iron and steel pipes)
Additional information
| 1. Scope | ||||||
|
1.1 This specification covers several grades of minimum-wall-thickness, seamless and welded, carbon and alloy-steel tubes intended for use at low temperatures. Some product sizes may not be available under this specification because heavier wall thicknesses have an adverse affect on low-temperature impact properties. 1.2 Supplementary Requirement S1 of an optional nature is provided. This shall apply only when specified by the purchaser. Note 1-For tubing smaller than 1/2 in. [12.7 mm] in outside diameter, the elongation values given for strip specimens in Table 1 shall apply. Mechanical property requirements do not apply to tubing smaller than 1/8 in. [3.2 mm] in outside diameter and with a wall thickness under 0.015 in. [0.4 mm].1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. The inch-pound units shall apply unless the "M" designation of this specification is specified in the order. |
||||||
| 2. Referenced Documents | ||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
