We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
Standard Specification for High-Strength Low-Alloy Columbium-Vanadium Structural Steel
Translate name
STANDARD published on 1.5.2018
Designation standards: ASTM A572/A572M-18
Note: WITHDRAWN
Publication date standards: 1.5.2018
SKU: NS-846466
The number of pages: 4
Approximate weight : 12 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
Keywords:
bars, bolted construction, bridges, buildings, columbium-vanadium, high-strength, low-alloy, plates, riveted construction, shapes, sheet piling, steel, structural steel, welded construction,, ICS Number Code 77.140.10 (Heat-treatable steels)
1. Scope | ||||||||
1.1 This specification covers five grades of high-strength low-alloy structural steel shapes, plates, sheet piling, and bars. Grades 42 [290], 50 [345], and 55 [380] are intended for riveted, bolted, or welded structures. Grades 60 [415] and 65 [450] are intended for riveted or bolted construction of bridges, or for riveted, bolted, or welded construction in other applications. 1.2 For applications, such as welded bridge construction, where notch toughness is important, notch toughness requirements are to be negotiated between the purchaser and the producer. 1.3 Specification A588/A588M shall not be substituted for Specification A572/A572M without agreement between the purchaser and the supplier. 1.4 The use of columbium, vanadium, titanium, nitrogen, or combinations thereof, within the limitations noted in Section 5, is required; the selection of type (1, 2, 3, or 5) is at the option of the producer, unless otherwise specified by the purchaser. (See Supplementary Requirement S90.) 1.5 The maximum thicknesses available in the grades and products covered by this specification are shown in Table 1. 1.6 When the steel is to be welded, a
welding procedure suitable for the grade of steel and intended use
or service is to be utilized. See Appendix X3 of Specification
A6/A6M for information on
weldability.
·
Structural shapes
· Sheet piling · Bars · Plates with widths up to and including 15 in. [380 mm] 1.7 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system is to be used independently of the other, without combining values in any way. 1.8 The text of this specification
contains notes or footnotes, or both, that provide explanatory
material. Such notes and footnotes, excluding those in tables and
figures, do not contain any mandatory requirements.
1.9 For structural products produced from
coil and furnished without heat treatment or with stress relieving
only, the additional requirements, including additional testing
requirements and the reporting of additional tests, of
Specification A6/A6M
apply.
1.10 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||
2. Referenced Documents | ||||||||
|
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
Latest update: 2024-04-17 (Number of items: 2 859 866)
© Copyright 2024 NORMSERVIS s.r.o.