Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM A589/A589M-06(2018)
Standard Specification for Seamless and Welded Carbon Steel Water-Well Pipe
Translate name
STANDARD published on 1.9.2018
The information about the standard:
Designation standards: ASTM A589/A589M-06(2018)
Publication date standards: 1.9.2018
SKU: NS-899423
The number of pages: 12
Approximate weight : 36 g (0.08 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM A589/A589M-06(2018) :
This specification covers four specific types of plain end or threaded and coupled carbon steel pipe for use in water wells. Water well pipe are classified into four types according to grads: type I, drive pipe; type II, water-well reamed and drifted pipe; type III, driven well pipe; and type IV, water-well casing pipe. The steel for both seamless and welded pipe shall be made by one of the following processes: open-hearth, electric furnace, or basic-oxygen. Tensile test, tension test, and hydrostatic test shall be required to conform to the requirements specified.
Keywords:
carbon steel pipe, seamless steel pipe, steel pipe, water well pipe, welded steel pipe,, ICS Number Code 23.040.10 (Iron and steel pipes)
Additional information
| 1. Scope | ||||||||||
|
1.1 This specification covers four specific types of plain end or threaded and coupled carbon steel pipe for use in water wells. 1.2 Each type of water well pipe shall conform to the following methods of manufacture and grade as specified on the purchase order: 1.2.1 Type I, Drive Pipe—Seamless or electric-resistance-welded, Grades A and B. 1.2.2 Type II, Water-Well Reamed and Drifted Pipe—Seamless or electric-resistance-welded, Grades A and B, or furnace-butt welded. 1.2.3 Type III, Driven Well Pipe—Seamless or electric-resistance-welded, Grades A and B, or furnace-butt welded. 1.2.4 Type IV, Water-Well Casing Pipe—Seamless or electric-resistance-welded, Grades A and B, or furnace-butt welded. 1.3 The values stated in either inch-pound units or in SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values in each system are not exact equivalents; therefore, each system is to be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. Note 1: The dimensionless designator NPS (nominal pipe size)
and DN (Nominal Diameter) have been substituted in this standard
for such traditional terms as “nominal diameter,” “size,” and
“nominal size.”
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||
| 2. Referenced Documents | ||||||||||
|
We recommend:
Updating of laws
Do you want to be sure about the validity of used regulations?
We offer you a solution so that you could use valid and updated legislative regulations.
Would you like to get more information? Look at this page.
