Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM A592/A592M-89(1999)
Standard Specification for High-Strength Quenched and Tempered Low-Alloy Steel Forged Fittings and Parts for Pressure Vessels
STANDARD published on 10.9.1999
The information about the standard:
Designation standards: ASTM A592/A592M-89(1999)
Note: WITHDRAWN
Publication date standards: 10.9.1999
SKU: NS-3261
The number of pages: 3
Approximate weight : 9 g (0.02 lbs)
Country: American technical standard
Category: Technical standards ASTM
Annotation of standard text ASTM A592/A592M-89(1999) :
Keywords:
Steel forgings-carbon steel, forged fittings/parts-low-alloy steel, high-strength/quenched and, tempered/vacuum-treated (for pressure vessels), spec, ICS Number Code 23.060.01 (Valves in general)
Additional information
| 1. Scope | ||||||||
|
1.1 This specification covers high-strength quenched and tempered low-alloy steel forged fittings and parts for pressure vessels. The maximum thickness of forgings under this specification shall be 1 1/2 in. [38 mm] for Grade A, and 3 3/4 in. [95 mm] for Grades E and F (4 in. [102 mm] maximum as heat treated). Note-These grades are similar to corresponding grades in Specification A517/A517M.1.2 Welding technique is of fundamental importance and it is presupposed that welding procedures will be in accordance with approved methods for the class of material used. 1.3 The values stated in either inch-pound units or SI (metric) units are to be regarded separately as the standard; within the text and tables, the SI units are shown in [brackets]. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. 1.4 Unless the order specifies the applicable "M" specification designation, the material shall be furnished to the inch-pound units. |
||||||||
| 2. Referenced Documents | ||||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
