Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM A738/A738M-03a
Standard Specification for Pressure Vessel Plates, Heat-Treated, Carbon-Manganese-Silicon Steel, for Moderate and Lower Temperature Service (Includes all amendments And changes 8/16/2017).
Automatically translated name:
Standard Specification for Pressure Vessel Plates, Heat-Treated, Carbon-Manganese-Silicon Steel, for Moderate and Lower Temperature Service
STANDARD published on 6.11.2003
The information about the standard:
Designation standards: ASTM A738/A738M-03a
Note: WITHDRAWN
Publication date standards: 6.11.2003
SKU: NS-3939
The number of pages: 4
Approximate weight : 12 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
Annotation of standard text ASTM A738/A738M-03a :
Keywords:
pressure vessel steel materials-plates, steel plate-carbon steel, plates-C-Mn-Si steel, heat-treated (for pressure vessels at moderate-low, temperatures), spec, ICS Number Code 77.140.30 (Steels for pressure purposes)
Additional information
| 1. Scope | ||
|
1.1 This specification covers heat-treated carbon-manganese-silicon steel plates intended for use in welded pressure vessels at moderate and lower temperature service. 1.2 Material under this specification is available in three strength levels, 75 ksi [515 MPa], 85 ksi [585 MPa], and 80 ksi [550 MPa], minimum ultimate tensile strengths. 1.3 The maximum thickness of Grade A plates is limited only by the capacity of the chemical composition and heat treatment to meet the specified mechanical property requirements. The maximum thickness of Grade B plates is limited to 2.5 in. [65 mm]. The maximum thickness of Grade C is limited to 6 in. 1.4 Grade A is the material that, prior to 1984, was covered by Specification A738 without a grade designation. 1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standards. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. |
||
| 2. Referenced Documents | ||
|
We recommend:
Updating of laws
Do you want to be sure about the validity of used regulations?
We offer you a solution so that you could use valid and updated legislative regulations.
Would you like to get more information? Look at this page.
