Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM A770/A770M-03(2007)
Standard Specification for Through-Thickness Tension Testing of Steel Plates for Special Applications
STANDARD published on 1.11.2007
The information about the standard:
Designation standards: ASTM A770/A770M-03(2007)
Note: WITHDRAWN
Publication date standards: 1.11.2007
SKU: NS-4101
The number of pages: 5
Approximate weight : 15 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
Annotation of standard text ASTM A770/A770M-03(2007) :
Keywords:
lamellar tearing, special steel-making processes, steel plate, through-thickness tension testing, Steel plate--specifications, Tensile properties/testing--steel, Thickness, Through-thickness testing ^
Additional information
| 1. Scope | ||
| 1.1 This specification covers the procedures and acceptance
standards for the determination of reduction of area using a
tension test specimen whose axis is perpendicular to the rolled
surfaces of steel plates 1 in. [25 mm] and greater in thickness.
The principal purpose of the testing is to provide a measure of the
resistance of a steel plate to lamellar tearing. (See Appendix X1.)
1.2 The values stated in either inch-pound units or SI units are to be regarded as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. 1.3 This specification is expressed in both inch-pound and SI units. However, unless the order specifies the applicable “M” specification designation (SI units), the material shall be furnished to inch-pound units. |
||
| 2. Referenced Documents | ||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
