Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM A821/A821M-15
Standard Specification for Steel Wire, Hard-Drawn for Prestressed Concrete Tanks
STANDARD published on 1.5.2015
The information about the standard:
Designation standards: ASTM A821/A821M-15
Note: WITHDRAWN
Publication date standards: 1.5.2015
SKU: NS-591104
The number of pages: 4
Approximate weight : 12 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM A821/A821M-15 :
Keywords:
prestressed concrete tanks, steel wire ,, ICS Number Code 77.140.15 (Steels for reinforcement of concrete)
Additional information
| 1. Scope | ||||||||||
|
1.1 This specification covers uncoated, high-strength, hard-drawn steel wire for use in the construction of prestressed concrete tanks and similar structures. In application, the wire is continuously wrapped on the structure maintaining tension by a device using a wire drawing die, or mechanical tensioning system without re-drawing. 1.2 This specification is applicable only to the condition of the wire as delivered to the purchaser. It is not applicable to the properties or condition of the wire after application. 1.2.1 Type A wire is to be tensioned by drawing through a wire drawing die or by a mechanical system without re-drawing. 1.2.2 Type B wire is drawn to finished size by the manufacturer for tensioning by a mechanical system without re-drawing. Note 1: Type A wire, when tensioned by drawing through a die,
may not function properly if the purchaser does not ensure that
during application the surface of the wire is free of rust and
foreign materials that can be detrimental to good wire drawing
practice. Further, the purchaser should ensure that proper wire
drawing techniques are followed, including adequate lubrication,
cooling, and proper die mechanics.
1.3 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard. 1.4 This specification is applicable for orders in either inch-pounds units (as Specification A821) or in SI units (as Specification A821M). 1.5 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. |
||||||||||
| 2. Referenced Documents | ||||||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
