Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM A886/A886M-16
Standard Specification for Steel Strand, Indented, Seven-Wire Stress-Relieved for Prestressed Concrete
Translate name
STANDARD published on 1.12.2016
The information about the standard:
Designation standards: ASTM A886/A886M-16
Note: WITHDRAWN
Publication date standards: 1.12.2016
SKU: NS-674976
The number of pages: 4
Approximate weight : 12 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM A886/A886M-16 :
Keywords:
indentations, prestressed concrete, seven-wire strand (tendon), steel wire ,, ICS Number Code 77.140.15 (Steels for reinforcement of concrete)
Additional information
| 1. Scope | ||||||
|
1.1 This specification covers two types and two grades of indented seven-wire uncoated, steel strand for use in prestressed concrete construction. The two types of strand are low-relaxation and stress-relieved (normal-relaxation). Grade 250I [1725I] and Grade 270I [1860I] have minimum tensile strengths of 250 ksi [1725 MPa] and 270 ksi [1860 MPa], respectively, based on the nominal area of the strand. 1.2 This specification is applicable for orders in either inch-pound units (as Specification A886) or in SI units (as Specification A886M). 1.3 The values stated in either inch-pound units or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the specification. |
||||||
| 2. Referenced Documents | ||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
