Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM B115-10(2021)
Standard Specification for Electrolytic Copper Cathode
Translate name
STANDARD published on 1.7.2021
The information about the standard:
Designation standards: ASTM B115-10(2021)
Publication date standards: 1.7.2021
SKU: NS-1029310
The number of pages: 9
Approximate weight : 27 g (0.06 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM B115-10(2021) :
This specification establishes the requirements for electrolytic copper cathode; electrorefined and electrowon. The cathode furnished shall conform to the chemical composition requirements specified. Cathodes shall withstand ordinary handling without breakage or excessive separation of nodules. They shall be substantially free of all foreign material; for example, copper sulfate, dirt, grease, and oil. Electrical resistivity of the cathodes shall be determined as the mean of results from four specimens.
Keywords:
cathode, copper, electrolytic copper, electrorefined copper, electrowon copper,, ICS Number Code 77.150.30 (Copper products)
Additional information
| Significance and Use | ||||||||||||||
|
13.1?Calculated values shall be rounded to the desired number of places as directed in Practice E29. |
||||||||||||||
| 1. Scope | ||||||||||||||
|
1.1?This specification establishes the requirements for electrolytic copper cathode; electrorefined and electrowon. 1.2?UnitsThe values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. Note 1:?Cathode produced to this specification corresponds to
the designation Cath as defined in Classification B224 and may be used to produce all other
coppers listed in Classification B224 that are normally produced from Cath
copper.
Note 2:?Grade 1 cathode conforms to the chemical compositional
requirements of Copper UNS No. C11040, except for oxygen, and is
suitable for the manufacture of wire rod as designated in
Specification B49.
1.3?The following hazard caveat applies to the test methods described in Annex A2 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||
| 2. Referenced Documents | ||||||||||||||
|
We recommend:
Updating of laws
Do you want to be sure about the validity of used regulations?
We offer you a solution so that you could use valid and updated legislative regulations.
Would you like to get more information? Look at this page.
