Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM B153-91(2003)e1
Standard Test Method for Expansion (Pin Test) of Copper and Copper-Alloy Pipe and Tubing (Includes all amendments And changes 8/16/2017).
Automatically translated name:
Standard Test Method for Expansion (Pin Test) of Copper and Copper-Alloy Pipe and Tubing
STANDARD published on 10.4.2003
The information about the standard:
Designation standards: ASTM B153-91(2003)e1
Note: WITHDRAWN
Publication date standards: 10.4.2003
SKU: NS-5505
The number of pages: 2
Approximate weight : 6 g (0.01 lbs)
Country: American technical standard
Category: Technical standards ASTM
Annotation of standard text ASTM B153-91(2003)e1 :
Keywords:
copper, copper alloy, expansion, pin test, pipe, tube, ICS Number Code 23.040.15 (Non-ferrous metal pipes)
Additional information
| 1. Scope | ||||
|
1.1 This test method establishes the requirements for the expansion pin test for copper and copper-alloy pipe and tubing in sizes up to and including 4 in. (102 mm) in outside diameter. Note 1—For tubes of sizes greater than 4 in. in outside diameter, the following flattening test, as described in the various pipe and tube specifications, is recommended as a substitute for the pin expansion test. For pipe and tubes over 4 in. in outside diameter in the annealed condition, a 4-in. long shall be cut from the end of one of the tubes. This 4-in. long sample shall be flattened so that a gage set at three times the wall thickness will pass over the pipe freely throughout the flattened part. The pipe or tube so tested shall develop no cracks or flaws visible to the unaided eye as a result of this test. In making the flattening test, the elements shall be slowly flattened by one stroke of the press.Note 2—The term "unaided eye," as used herein, permits the use of corrective lenses necessary to obtain normal vision. 1.2 The values stated in inch-pound units are to be regarded as the standard. SI values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
| 2. Referenced Documents | ||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
