We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
Standard Specification for Hard-Drawn Copper-Clad Steel Wire
Translate name
STANDARD published on 1.10.2019
Designation standards: ASTM B227-15(2019)
Publication date standards: 1.10.2019
SKU: NS-972318
The number of pages: 4
Approximate weight : 12 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
This specification covers bare hard-drawn round copper-clad steel wire. The surface of the wire shall be smooth and free from imperfections not consistent with good commercial practice. The wire shall conform to the tensile requirements. Specimens shall be twisted to destruction and shall not reveal under test any seams, pits, slivers, or surface imperfections of sufficient magnitude to indicate inherent defects or imperfections in the wire. The electrical resistance of the wire shall be determined by resistance measurements. The finished wire shall contain no joints or splices made at finished size.
Keywords:
clad steel electrical conductor, copper electrical conductor-copper-clad steel, copper-clad steel electrical conductor, electrical conductor, hard drawn copper-clad steel wire, steel wire-copper-clad,, ICS Number Code 77.140.65 (Steel wire, wir ropes and link chains)
1. Scope | ||||||
1.1 This specification covers bare hard-drawn round copper-clad steel wire for electrical purposes (Note 1). Note 1: Wire ordered to this specification is not intended for
redrawing. If wire is desired for this purpose, consult the
manufacturer.
1.2 Four grades of wire are specified, designated as follows (Note 2): Grade 40 HS, Grade 40 EHS, Grade 30 HS, and Grade 30 EHS. Note 2: The grades covered by this specification correspond to
the following commercial designations:
1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||
2. Referenced Documents | ||||||
|
Latest update: 2024-05-01 (Number of items: 2 896 514)
© Copyright 2024 NORMSERVIS s.r.o.