We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
Standard Specification for U-Bend Seamless Copper and Copper Alloy Heat Exchanger and Condenser Tubes
STANDARD published on 1.4.2008
Designation standards: ASTM B395/B395M-08
Note: WITHDRAWN
Publication date standards: 1.4.2008
SKU: NS-6533
The number of pages: 12
Approximate weight : 36 g (0.08 lbs)
Country: American technical standard
Category: Technical standards ASTM
Keywords:
condenser tube, copper, copper alloy, dual-gage, evaporator, heat exchanger, U-bend tube, C10200, C10300, C10800, C12000, C12200, C14200, C19200, C23000, C44300, C44400, C44500, C60800, C68700, C70400, C70600, C70620, C71000, C71500, C71520, C72200, Aluminum bronzes--specifications, Brass pipe/tube--specifications, Bronze pipe/tube--specifications, Condenser and heat exchanger systems--copper/copper alloy, Seamless Cu/Cu alloy tube--specifications
Significance and Use | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
For purpose of determining compliance
with the specified limits for requirements of the properties listed
in the following table, an observed value or a calculated value
shall be rounded as indicated in accordance with the rounding
method of Practice E 29.
|
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
1.1 This specification establishes the requirements for condenser, evaporator, and heat exchanger U-bend tubes that are manufactured from seamless copper and copper alloy tube. 1.2 The following safety hazard caveat pertains only to the test methods described in this specification. 1.2.1 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use. 1.3 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.4 This specification is applicable to product 2 in. [50 mm] or less, inclusive, in diameter. 1.5 The product shall be produced from
one of the following coppers or copper alloys, as specified in the
ordering information:
A Designations listed in Classification B 224. |
||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
Latest update: 2024-03-25 (Number of items: 2 885 931)
© Copyright 2024 NORMSERVIS s.r.o.