Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM B466/B466M-18
Standard Specification for Seamless Copper-Nickel Pipe and Tube
Translate name
STANDARD published on 1.3.2018
The information about the standard:
Designation standards: ASTM B466/B466M-18
Publication date standards: 1.3.2018
SKU: NS-845351
The number of pages: 6
Approximate weight : 18 g (0.04 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM B466/B466M-18 :
This specification covers the requirements for seamless UNS C70400, C70600, C71000, C71500, C71520, and C72200 copper-nickel pipes and tubes in straight lengths suitable for engineering applications. UNS C70620 and C71520 copper alloys are intended for products that are to be welded subsequently. Each product should be manufactured from cast billets by hot extrusion or piercing and then subjected to cold working and annealing. The standard tempers for the products in this specification are soft annealed (O60), light drawn (H55), hard drawn (H80), and hard drawn and end annealed (HE80). Pipe and tube tensile properties, Rockwell hardness, and test performance should conform to the values specified herein. Performance requirements include those from expansion, flattening, and eddy Current tests.
Keywords:
copper-nickel, pipe, seamless, tube, UNS No. C70400, UNS No. C70600, UNS No. C70620, UNS No. C71000, UNS No. C71500, UNS No. C71520, UNS No. C72200,, ICS Number Code 77.150.30 (Copper products)
Additional information
| 1. Scope | ||||||||||||||||||||||||||||||
|
1.1 This specification establishes the requirements for seamless copper-nickel pipe and tube in straight lengths, suitable for general engineering purposes. The alloys involved are copper alloys UNS Nos. C70400, C70600, C70620, C71000, C71500, C71520, and C72200. 1.1.1 Copper alloys UNS Nos. C70620 and C71520 are intended for product that will be subsequently welded. 1.2 Units—Values stated in either SI units or inch-pound units are to be regarded separately as standard. Within the text, SI units are shown in brackets. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the specification. 1.3 The following safety hazard caveat pertains only to the test methods described in this specification: 1.3.1 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||
|
We recommend:
Updating of laws
Do you want to be sure about the validity of used regulations?
We offer you a solution so that you could use valid and updated legislative regulations.
Would you like to get more information? Look at this page.
