Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM B830-18
Standard Specification for Uniform Test Methods and Frequency
Translate name
STANDARD published on 15.6.2018
The information about the standard:
Designation standards: ASTM B830-18
Note: WITHDRAWN
Publication date standards: 15.6.2018
SKU: NS-910810
The number of pages: 4
Approximate weight : 12 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM B830-18 :
Keywords:
acceptable quality level (AQL), average outgoing quality (AOQ), control chart, lot, lower specification limit (LSL), process average, process control ratio (CPK), skip-lot inspection, statistical process control (SPC), upper specification limit (USL),, ICS Number Code 19.020 (Test conditions and procedures in general)
Additional information
| 1. Scope | ||||||
|
1.1 This specification covers a standard basis for uniform testing and frequency to determine physical and electrical compliance for aluminum and copper drawing stock, and aluminum and copper conductors. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.2.1 Exception—Resistivity is measured in SI units. 1.3 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||
| 2. Referenced Documents | ||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
