Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM B90/B90M-12
Standard Specification for Magnesium-Alloy Sheet and Plate
STANDARD published on 1.11.2012
The information about the standard:
Designation standards: ASTM B90/B90M-12
Note: WITHDRAWN
Publication date standards: 1.11.2012
SKU: NS-8698
The number of pages: 8
Approximate weight : 24 g (0.05 lbs)
Country: American technical standard
Category: Technical standards ASTM
Annotation of standard text ASTM B90/B90M-12 :
Keywords:
ICS Number Code 77.120.20 (Magnesium and magnesium alloys)
Additional information
| 1. Scope | |||||||||||||
|
1.1 This specification covers magnesium alloys in sheet and plate form designated as shown in
|
Composition %A |
||||||||||||
|
|
Al |
Mn |
R.E. |
Zn |
Zr |
Ca |
Cu |
Fe |
Ni |
Si |
Each |
Total |
Mg |
|
AZ31B |
2.5-3.5 |
0.20-1.0 |
. . . |
0.6-1.4 |
. . . |
0.04 |
0.05 |
0.005 |
0.005 |
0.10 |
. . . |
0.30 |
Remainder |
1.2 The values stated in either
inch-pound or SI units are to be regarded separately as standards.
The SI units are shown in brackets or in separate tables or
columns. The values stated in each system are not exact
equivalents; therefore, each system must be used independent of the
other. Combining values from the two systems may result in
nonconformance with the specification.
1.3 Unless the order specifies the “M” specification designation, the material shall be furnished to the inch-pound units.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
|
Standard Test Methods for Tension Testing Wrought and Cast Aluminum- and Magnesium-Alloy Products |
|
|
MIL-STD-129 |
Marking for Shipment and Storage |
|
Fed. Std. No. 184 |
Identification Marking of Aluminum, Magnesium and Titanium |
|
Fed. Std. No. 123 |
Marking for Shipment (Civil Agencies) |
|
Standard Test Methods for Tension Testing Wrought and Cast Aluminum- and Magnesium-Alloy Products (Metric) |
|
|
Standard Practice for Using Significant Digits in Test Data to Determine Conformance with Specifications |
|
|
Standard Test Method for Analysis of Magnesium and Magnesium Alloys by Atomic Emission Spectrometry |
|
|
Standard Practices for Packaging/Packing of Aluminum and Magnesium Products |
|
|
Standard Practice for Sampling Wrought Nonferrous Metals and Alloys for Determination of Chemical Composition |
We recommend:
Updating of laws
Do you want to be sure about the validity of used regulations?
We offer you a solution so that you could use valid and updated legislative regulations.
Would you like to get more information? Look at this page.
