We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
Standard Specification for Joints for Concrete Gravity Flow Sewer Pipe, Using Rubber Gaskets
Translate name
STANDARD published on 15.7.2019
Designation standards: ASTM C1628-19
Note: WITHDRAWN
Publication date standards: 15.7.2019
SKU: NS-955573
The number of pages: 7
Approximate weight : 21 g (0.05 lbs)
Country: American technical standard
Category: Technical standards ASTM
Keywords:
concrete pipe, joints, leak resistant, rubber gaskets, sewer pipe,, ICS Number Code 93.030 (External sewerage systems)
1. Scope | ||||||||||||||||
1.1 This specification covers flexible leak resistant joints for concrete gravity flow sewer pipe using rubber gaskets for sealing the joints, where measurable or defined infiltration or exfiltration is a factor of the design. The specification covers the design of joints and the requirements for rubber gaskets to be used therewith, for pipe conforming in all other respects to Specifications C14, C76, C655, C985, and C1417, provided that, if there is conflict in permissible variations in dimension, the requirements of this specification shall govern for joints. Note 1: Infiltration or exfiltration quantities for an
installed pipeline are dependent upon many factors other than the
joints, and allowable quantities must be covered by other
specifications and suitable testing of the installed pipeline and
system. This specification covers the design, material, and
performance of the rubber gasket joint only. Joints covered by this
specification are for hydrostatic pressures up to 13 psi without
leakage, when plant tested in accordance with Section 10.
1.2 The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||
2. Referenced Documents | ||||||||||||||||
|
Do you want to be sure about the validity of used regulations?
We offer you a solution so that you could use valid and updated legislative regulations.
Would you like to get more information? Look at this page.
Latest update: 2024-05-17 (Number of items: 2 902 148)
© Copyright 2024 NORMSERVIS s.r.o.