Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM C1797-16e1
Standard Specification for Ground Calcium Carbonate and Aggregate Mineral Fillers for use in Hydraulic Cement Concrete (Includes all amendments And changes 1/1/2018).
Translate name
STANDARD published on 29.8.2016
The information about the standard:
Designation standards: ASTM C1797-16e1
Note: WITHDRAWN
Publication date standards: 29.8.2016
SKU: NS-651565
The number of pages: 5
Approximate weight : 15 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Mineral materials and productsConcrete and concrete products
Annotation of standard text ASTM C1797-16e1 :
Keywords:
aggregate mineral filler, ground calcium carbonate, hydraulic cement concrete, limestone, mineral filler, calcium carbonate, EDTA, limestone, magnesium carbonate, titration,, ICS Number Code 91.100.15 (Mineral materials and products), 91.100.30 (Concrete and concrete products)
Additional information
| Significance and Use | ||||||||||||||||||||||||||||||||||||
| A1.3 Significance and Use
A1.3.1 This test method provides analytical procedures to determine the major chemical constituents of limestone (see Note 1). The percentages of specific constituents that determine a material’s quality or fitness for use are of significance depending upon the purpose or end use of the material. Results obtained may be used in relation to specification requirements. Note A1.1: This test method can be applied to other calcareous
materials if provisions are made to compensate for known
interferences.
|
||||||||||||||||||||||||||||||||||||
| 1. Scope | ||||||||||||||||||||||||||||||||||||
|
1.1 This specification applies to ground calcium carbonate (GCC is a type of ground limestone) and other finely divided aggregate mineral filler (AMF) materials for use in concrete mixtures. The specification defines the types of GCC and AMF materials for use in concrete. 1.2 If concrete in service is subject to sulfate exposure, fillers derived from ground limestone should not be used unless mitigation methods are used. Note 1: American Concrete Institute (ACI) technical documents
201.2R, 318, 332, and 350 contain useful information and code
requirements dealing with sulfate exposure in service. Soluble
sulfate in water can be determined in accordance with Test Method
D516 or Test Method
D4130. Percent sulfate by
mass in soil can be determined by Test Method C1580.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. Note 2: Sieve size is identified by its standard designation
in Specification E11. The
alternative designation given in parentheses is for information
only and does not represent a different standard sieve
size.
1.4 The text of this standard references notes and footnotes, which provide explanatory information. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||
|
