We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
Standard Specification for Flow Table for Use in Tests of Hydraulic Cement
Translate name
STANDARD published on 1.6.2020
Designation standards: ASTM C230/C230M-20
Note: WITHDRAWN
Publication date standards: 1.6.2020
SKU: NS-999932
The number of pages: 7
Approximate weight : 21 g (0.05 lbs)
Country: American technical standard
Category: Technical standards ASTM
Keywords:
ICS Number Code 91.100.10 (Cement. Gypsum. Lime. Mortar)
1. Scope | ||
1.1?This specification covers requirements for the flow table and accessory apparatus (Note 1) used in making flow tests for consistency of mortars in tests of hydraulic cement, such as but not limited to Test Method C1437. Note 1:?To help clarify the design of the flow table and
accessory apparatus see the drawing in Fig. 1 [Fig. 2]. This drawing is for
informational purposes only.
FIG. 1?Flow Table and Accessory Apparatus (Partial) (IP) FIG. 1?Flow Table and Accessory Apparatus (Partial) (IP) FIG. 2?Flow Table and Accessory Apparatus (Partial) [SI] FIG. 2?Flow Table and Accessory Apparatus (Partial) [SI] FIG. 2?Flow Table and Accessory Apparatus (Partial) [SI] 1.2?The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. It is permissible to use an inch-pound caliper and mold with a SI flow table or a SI caliper and mold with an inch-pound flow table. It is not permissible to mix a SI mold with an inch-pound caliper or an inch-pound mold with a SI caliper. 1.3?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||
2. Referenced Documents | ||
|
Do you want to be sure about the validity of used regulations?
We offer you a solution so that you could use valid and updated legislative regulations.
Would you like to get more information? Look at this page.
Latest update: 2024-05-14 (Number of items: 2 898 634)
© Copyright 2024 NORMSERVIS s.r.o.