Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM D1525-07
Standard Test Method for Vicat Softening Temperature of Plastics
STANDARD published on 1.3.2007
The information about the standard:
Designation standards: ASTM D1525-07
Note: WITHDRAWN
Publication date standards: 1.3.2007
SKU: NS-17561
The number of pages: 9
Approximate weight : 27 g (0.06 lbs)
Country: American technical standard
Category: Technical standards ASTM
Annotation of standard text ASTM D1525-07 :
Keywords:
plastics, thermoplastics, Vicat softening temperature, ICS Number Code 83.080.01 (Plastics in general)
Additional information
| Significance and Use | ||||||||||||||||||
|
Data obtained by this test method may be used to compare the heat-softening qualities of thermoplastic materials. This test method is useful in the areas of quality control, development, and characterization of plastic materials. |
||||||||||||||||||
| 1. Scope | ||||||||||||||||||
|
1.1 This test method covers determination of the temperature at which a specified needle penetration occurs when specimens are subjected to specified controlled test conditions. 1.2 This test method is not recommended for ethyl cellulose, nonrigid poly(vinyl chloride), poly(vinylidene chloride), or other materials having a wide Vicat softening range. 1.3 The values stated in SI units are to be regarded as standard. 1.4 Due to the potential safety and environmental hazards associated with mercury-filled thermometers, the use of alternative temperature measuring devices (such as thermocouples and RTDs) is encouraged. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1—This test method and ISO 306:1987(E) are technically equivalent, with the exception of the allowance for creep, prior to beginning the test, in this test method. |
||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
