ASTM D3028-95

1.1 This test method covers the determination of sliding (kinetic) friction of plastic solids or sheeting (as moving specimens) when sliding against similar or dissimilar substances (Note 1) (as fixed specimens) through the speed range of approximately 0.10 to 3.00 m/s. The instrument used is a variable speed, variable normal-force frictionometer. ,

1.2 Rigid or self-supporting specimens must be machined to specified dimensions. Normally, sheeting exceeding 1.00 mm (0.040 in.) in thickness should not be tested on a mounting wheel of standard diameter.

1.3 Two testing procedures are included. Selection of a procedure is determined by the specific interests of the investigator. The procedures are:

1.3.1 Procedure A -Determination of variable-velocity kinetic coefficients, and

1.3.2 Procedure B -Determination of constant-velocity kinetic coefficients over an extended period of time.

1.4 Test data obtained by this test method is relevant and appropriate for use in engineering design.

1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use .