We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
Standard Test Methods for Measurement of Extreme Pressure Properties of Fluid Lubricants (Falex Pin and Vee Block Methods)
STANDARD published on 1.12.2014
Designation standards: ASTM D3233-93(2014)
Note: WITHDRAWN
Publication date standards: 1.12.2014
SKU: NS-580630
The number of pages: 11
Approximate weight : 33 g (0.07 lbs)
Country: American technical standard
Category: Technical standards ASTM
Keywords:
extreme pressure, Falex Pin and Vee Block, load-carrying, lubricant, wear,, ICS Number Code 75.100 (Lubricants, industrial oils and related products)
Significance and Use | |||||||||||||||||||||||||||||||||||||||||||||||
5.1 Evaluations by both test methods differentiate between fluids having low, medium, and high levels of extreme-pressure properties. The user should establish any correlation between results by either method and service performance. Note 3: Relative ratings by both test methods on the reference
fluids covered in Table 1 and
Table 2 are in good general
agreement with four-ball weld-point relative ratings obtained on
these same reference fluids, covered in Test Method D2783.
|
|
Repeatability |
|
|
|
|
Reproducibility |
|
|
||||||||||||||||||||||||||||||||||||||
|
|
s = 0.0624 |
|
|
|
|
S = 0.137 |
|
|
||||||||||||||||||||||||||||||||||||||
|
|
r = 0.179 (TL)E |
|
|
|
|
R = 0.391 (TL)E |
|
|
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
Standard Specification for Free-Cutting Brass Rod, Bar and Shapes for Use in Screw Machines |
|
Standard Test Method for Measurement of Extreme-Pressure Properties of Lubricating Fluids (Four-Ball Method) |
|
Standard Test Method for Measuring Wear Properties of Fluid Lubricants (Falex Pin and Vee Block Method) |
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
Latest update: 2024-05-05 (Number of items: 2 897 047)
© Copyright 2024 NORMSERVIS s.r.o.