Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM D3775-17e1
Standard Test Method for End (Warp) and Pick (Filling) Count of Woven Fabrics (Includes all amendments And changes 8/4/2023).
Translate name
STANDARD published on 1.9.2017
The information about the standard:
Designation standards: ASTM D3775-17e1
Note: WITHDRAWN
Publication date standards: 1.9.2017
SKU: NS-810977
The number of pages: 4
Approximate weight : 12 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM D3775-17e1 :
Keywords:
construction, end count, fabric, pick count, woven,, ICS Number Code 59.080.30 (Textile fabrics)
Additional information
| Significance and Use | ||||||||||
|
5.1 This test method is considered satisfactory for acceptance testing of commercial shipments because it has been used extensively in the trade for that purpose. 5.1.1 If there are differences of practical significance between reported test results for two laboratories (or more), comparative test should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, use the samples for such a comparative test that are as homogeneous as possible, drawn from the same lot of material as the samples that resulted in disparate results during initial testing and randomly assigned in equal numbers to each laboratory. The test results from the laboratories involved should be compared using a statistical test for unpaired data, a probability level chosen prior to the testing series. If bias is found, either its cause must be found and corrected, or future test results for that material must be adjusted in consideration of the known bias. 5.1.2 This test method is suitable for use with narrow fabrics when the count across the total width is measured in the narrow direction and extrapolated to the number of yarns per centimeter (inch). |
||||||||||
| 1. Scope | ||||||||||
|
1.1 This test method covers the measurement of end (warp) and pick (filling) count and is applicable to all types of woven fabrics. Note 1: Historically, the term fabric count has been used to
describe the end and pick count of woven fabrics. The terms end
count and pick count are replacing the term fabric count, to
provide clarity.
1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.2.1 Throughout this document, there will be some instances in which the units do not convert 1:1. This is to acknowledge that this is a global document and that different parts of the world use different units of measurement. Organizations using the metric system wil report the count per 1 cm. Organizations using the English system will report the count per 1 in. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health and environmental practices and determine the applicability of regulatory limitations prior to use. Note 2: For a current test method for the wale and course
count of weft knitted fabrics, refer to Test Method D8007.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||
| 2. Referenced Documents | ||||||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
