ASTM D3542-08(2013)..
ASTM D4014-03(2012)..
ASTM D4071-84(2011)..
ASTM D4788-03(2013)..
ASTM D5977-03(2012)..
ASTM D6297-13
Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM D4580/D4580M-12
Standard Practice for Measuring Delaminations in Concrete Bridge Decks by Sounding
STANDARD published on 15.12.2012
The information about the standard:
Designation standards: ASTM D4580/D4580M-12
Note: WITHDRAWN
Publication date standards: 15.12.2012
SKU: NS-27789
The number of pages: 4
Approximate weight : 12 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM D4580/D4580M-12 :
Keywords:
concrete bridge deck, delamination, sounding, ICS Number Code 93.040 (Bridge construction)
Additional information
| Significance and Use |
|
2.1 This practice may be used in conjunction with other methods in determining the general condition of concrete bridge decks. 2.2 This practice may be used in determining specific areas of delamination requiring repair. |
| 1. Scope |
|
1.1 This practice covers procedures for surveying concrete bridge decks by sounding to determine delaminations in the concrete. It is not intended that the procedures described herein are to be used on bridge decks that have been overlaid with bituminous mixtures. The procedures may be used on bridge decks that have been overlaid with portland cement concrete mixtures; however, areas indicated to be delaminated may have a lack of bond between the overlay and the underlying bridge deck (Note 1). 1.2 The following three procedures
are covered in this practice:
1.2.1 Procedure A, Electro-Mechanical Sounding Device—This procedure uses an electric powered tapping device, sonic receiver, and recorder mounted on a cart. The cart is pushed across the bridge deck and delaminations are recorded on the recorder. 1.2.2 Procedure B, Chain Drag—This procedure consists of dragging a chain over the bridge deck surface. The detection of delaminations is accomplished by the operator noting dull or hollow sounds. Tapping the bridge deck surface with a steel rod or hammer may be substituted for the chain drag. 1.2.3 Procedure C, Rotary Percussion1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
Similar standards:
Historical
1.9.2013
Historical
15.7.2012
Historical
1.12.2011
Historical
1.9.2013
Historical
15.7.2012
Historical
1.7.2013
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
