ASTM D5143-06

This test method can be used to make reliable and reproducible measurements in soil in the range from the detection level to the percent levels of each of seven explosive compounds.

This test method does not attempt to quantify the reactivity or mobility of the explosive content, only the concentration of these compounds in the soil.

This test method can be used to determine the extent of contamination resulting from the use, misuse, or spillage of explosive compounds. It is useful to determine the effectiveness of clean-up actions at disposal sites, and to determine the environmental impact at explosives disposal, manufacturing, or storage sites.

1.1 This test method describes a procedure for the laboratory determination of the concentration of nitroaromatic and nitramine explosives in soil. The explosives involved in this test method are as follows: HMX (octahydro-1,3,5,7-tetranitro-1,3,5,7-tetrazocine), RDX (hexahydro-1,3,5-trinitrol-1,3,5-triazine), TNT (2,4,6-trinitrotoluene), TNB (1,3,5 trinitrobenzene), DNB (1,3 dinitrobenzene), tetryl (methyl-2,4,6-trinitrophenylnitramine), and 2,4-DNT (2,4-dinitrotoluene).

1.2 All observed and calculated values shall conform to the guidelines for significant digits and rounding established in Practice D 6026

1.2.1 The method used to specify how data are collected, calculated, or recorded in this standard is not directly related to the accuracy to which the data can be applied in design of other uses, or both. How one applies the results obtained using this standard is beyond its scope.

1.3 The values stated in SI units are to be regarded as the standard.

This standard does not purport to address the safety concerns associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.