ASTM D5295/D5295M-18

3.1 The success of a waterproofing application depends on, among other things, the type, smoothness, and cleanliness of the concrete surface being coated. This guide describes conditioning or repairing of the concrete surface by the removal or other constructive modification of those surface defects that can affect the performance of the waterproofing system. It covers surface preparation by mechanical, chemical, and blast cleaning methods in order to provide good adhesion between the waterproofing system and the concrete as well as the effect and control of various surface contaminants. It also addresses the evaluation of concrete moisture content to ensure optimal initial bond. (See also ACI 515.)

3.2 This guide is not intended to offer guidelines for the selection of a suitable waterproofing system; the use of specific application techniques; or the design and installation of flashing, terminations, expansion joint details, etc. (For definitions of terms, see Terminology D1079.)

3.3 This guide is not intended to offer guidelines for the control of water vapor drive through the concrete which could affect long term performance of the bond between the concrete and waterproofing.

3.4 The recommended procedures described herein are minimums; the waterproofing materials manufacturer may require more strict or specific procedures for the preparation of concrete surfaces for the application of the manufacturer's specific system.

1.1 This guide provides recommendations for the preparation of concrete surfaces prior to the application of adhered (bonded) waterproofing.

1.2 This guide is directed primarily toward installations of new concrete, but is also applicable for existing concrete installations. (See also ACI 116 and ACI 546.)

1.3 This guide does not apply to loose laid systems, bentonite systems, lead, or the like.

1.4 This guide does not apply to applications involving insulating concrete.

1.5 This guide does not apply to applications involving lightweight structural concrete.

1.6 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.8 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.