Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM D5989-14
Standard Specification for Extruded and Monomer Cast Shapes Made from Nylon (PA)
STANDARD published on 1.5.2014
The information about the standard:
Designation standards: ASTM D5989-14
Note: WITHDRAWN
Publication date standards: 1.5.2014
SKU: NS-33340
The number of pages: 7
Approximate weight : 21 g (0.05 lbs)
Country: American technical standard
Category: Technical standards ASTM
Annotation of standard text ASTM D5989-14 :
Keywords:
monomer cast, nylon, plates, recycled plastic, rod, shapes, sheet, tubular bar, ICS Number Code 83.020 (Manufacturing processes in the rubber and plastics industries)
Additional information
| 1. Scope | ||||||||||||||||
|
1.1 This specification covers requirements and test methods for the material, dimensions, and workmanship, and the properties of extruded and cast sheet, plate, rod and tubular bar, excluding pipe and fittings, manufactured from nylon or monomers. 1.2 The properties included in this specification are those required for the compositions covered. Section 1.3 This specification allows for the use of recycled plastics (as defined in Guide D7209). 1.4 The values stated in inch-pound units are regarded as standard. The values in parentheses are for information only. 1.5 The following precautionary caveat pertains only to the test method portions of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
|
|
Standard Test Methods for Determining the Izod Pendulum Impact Resistance of Plastics
|
|
Standard Test Method for Tensile Properties of Plastics
|
|
Standard Test Methods for Flexural Properties of Unreinforced and Reinforced Plastics and Electrical Insulating Materials
|
LP-410A
|
Nylon Stock Shapes
|
|
Standard Practice for Packaging/Packing of Plastics
|
|
Standard Classification System for and Basis of Specification for Polyamide Molding and Extrusion Materials (PA)
|
|
Standard Guide for Waste Reduction, Resource Recovery, and Use of Recycled Polymeric Materials and Products (Withdrawn 2015)
|
|
Standard Terminology Relating to Plastics (Includes all amendments and changes 6/15/2026). |
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
