Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM D6334-07
Standard Test Method for Sulfur in Gasoline by Wavelength Dispersive X-Ray Fluorescence
STANDARD published on 1.12.2007
The information about the standard:
Designation standards: ASTM D6334-07
Note: WITHDRAWN
Publication date standards: 1.12.2007
SKU: NS-34711
The number of pages: 5
Approximate weight : 15 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
Annotation of standard text ASTM D6334-07 :
Keywords:
analysis, gasoline, gasoline-oxygenate blend, petroleum, spectrometry, sulfur, X-ray, Fuel sulfur, Gasoline, Sulfur--petroleum products, Wavelength dispersive X-ray fluorescence (WDXRF), XRF (X-ray fluorescence)--petroleum products, ICS Number Code 71.040.50 (Physicochemical methods of analysis), 75.160.20 (Liquid fuels)
Additional information
| Significance and Use | ||||||||||||||||||||||
|
Knowledge of the presence of sulfur in petroleum products, especially fuels, helps predict performance characteristics, potential corrosion problems, and vehicle emission levels. In addition, some regulatory agencies mandate reduced levels of sulfur in reformulated type gasolines. |
||||||||||||||||||||||
| 1. Scope | ||||||||||||||||||||||
|
1.1 This test method covers the quantitative determination of total sulfur in gasoline and gasoline-oxygenate blends. The Pooled Limit of Quantitation (PLOQ) was determined to be 15 mg/kg. Therefore, the practical range for this test method is from 15 to 940 mg/kg. Note 1—This concentration range is based on that used in the interlaboratory round robin, which shows that the range of sulfur in the round robin samples was from 1.5 to 940 mg/kg; however, below 15 mg/kg, the reproducibility approaches 100 % of the concentration. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitation prior to use. 1.3 The values stated in SI units are to be regarded as the standard. The preferred units are mg/kg sulfur. |
||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||
|
We recommend:
Technical standards updating
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
