We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
Standard Test Method for Cone/Plate Viscosity at a 500 s-1 Shear RateTranslate name
STANDARD published on 1.6.2018
Designation standards: ASTM D7395-18
Publication date standards: 1.6.2018
The number of pages: 3
Approximate weight : 9 g (0.02 lbs)
Country: American technical standard
Category: Technical standards ASTM
No. 4 Ford cup-alternative, rheology-paints/related coatings/materials, viscometer-cone/plate, viscosity-paints/related coatings/materials,, ICS Number Code 87.040 (Paints and varnishes)
|Significance and Use|
4.1 This test has been used to measure viscosities of automotive topcoats in place of No. 4 Ford cup measurements and has provided an equivalent ability to evaluate whether the paint meets specifications and is sprayable.
4.2 The method could be considered as an alternative to No. 4 Ford cup and other efflux cup measurements for other products as well.
4.3 The type of viscometer described in this method gives better temperature control than Ford and other efflux cups and is expected to give better precision.
4.4 This test method is suitable for all paints and related materials whether they are Newtonian in behavior or not.
1.1 This test method covers the determination of the viscosity of paints and related products using a cone/plate viscometer at a shear rate of 500 s-1.
1.2 Viscosity values obtained by this method may be used as an alternative to results from No. 4 Ford cup measurements. The values from this method do not replicate Ford cup results, but can be used for quality control, producer-user specifications and viscosity reduction in the same manner that Ford cups are used.
1.3 If viscosity at a higher shear rate is needed, Test Method , which describes viscosity measurement at 10 000 s-1 to 12 000 s-1 may be used.
1.4 The values stated in SI units are to be regarded as standard. The values given in parentheses are provided for information only and are not considered standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
|2. Referenced Documents|
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
Latest update: 2022-12-07 (Number of items: 2 667 430)
© Copyright 2022 NORMSERVIS s.r.o.