Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM D7487-13e1
Standard Practice for Polyurethane Raw Materials: Polyurethane Foam Cup Test (Includes all amendments And changes 8/13/2018).
Automatically translated name:
Standard Practice for Polyurethane Raw Materials: Polyurethane Foam Cup Test
STANDARD published on 1.11.2013
The information about the standard:
Designation standards: ASTM D7487-13e1
Note: WITHDRAWN
Publication date standards: 1.11.2013
SKU: NS-633412
The number of pages: 5
Approximate weight : 15 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
The category - similar standards:
Annotation of standard text ASTM D7487-13e1 :
Keywords:
cream time, cup test, foam testing, formulated polyol, free rise density, free rise height, free rise time, initiation time, isocyanate, polyurethane, pull time, raw material, resin blend, settle back, sigh back, sink back, string gel time, tack free time, top of cup time,, ICS Number Code 83.080.10 (Thermosetting materials)
Additional information
| Significance and Use |
|
5.1 General Utility: 5.1.1 It is useful to verify catalyst levels in a resin blend or a polyurethane system. 5.1.2 This practice is suitable for research, quality control, specification testing, and process control. 5.2 Limitations: 5.2.1 Several of the measured parameters are subjective. Therefore, operator-to-operator variability and lab-to-lab variability can be much higher than that of a single operator. 5.2.2 The variability of this practice is dependent on the consistency of mixing of the reactants. 5.2.3 The estimation of precision in this practice is based on typical formulations for rigid and flexible foams. Formulations with faster reaction times will likely have greater variability, particularly cream time (initiation time). Formulations with slower reaction times will likely have greater variability in the measurement of free rise time. 5.2.4 It is possible that low-level (ppm, ppb) ingredient contamination will not be detectable using this practice. Confirmation of such contamination will potentially require large-scale (~ 20 litres) tests and is out of the scope of this practice. |
| 1. Scope |
|
1.1 This practice covers the determination of cream time (initiation time), top of cup time, free rise time, free rise height, string gel time (pull time), tack free time, settle back, and free rise density of polyurethane foam formulations using a cup foam test. 1.2 Typical definitions, terms, and techniques are described; including procedures for mixing and transferring samples to the foaming container; and data gathering and evaluation. However, agreement between the customer and the testing laboratory for all these items must be obtained prior to use. 1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
We recommend:
Updating of laws
Do you want to be sure about the validity of used regulations?
We offer you a solution so that you could use valid and updated legislative regulations.
Would you like to get more information? Look at this page.
