We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
Standard Test Methods for Density and Specific Gravity (Relative Density) of Plastics by DisplacementTranslate name
STANDARD published on 1.7.2020
Designation standards: ASTM D792-20
Publication date standards: 1.7.2020
The number of pages: 6
Approximate weight : 18 g (0.04 lbs)
Country: American technical standard
Category: Technical standards ASTM
density, relative density, specific gravity,, ICS Number Code 83.080.01 (Plastics in general)
|Significance and Use|
5.1 The specific gravity or density of a solid is a property that is conveniently measured to identify a material, to follow physical changes in a sample, to indicate degree of uniformity among different sampling units or specimens, or to indicate the average density of a large item.
5.2 Changes in density of a single material are due to localized differences in crystallinity, loss of plasticizer, absorption of solvent, or to other causes. It is possible that portions of a sample differ in density because of their differences in crystallinity, thermal history, porosity, and composition (types or proportions of resin, plasticizer, pigment, or filler).
5.3 Density is useful for calculating strength-weight and cost-weight ratios.
1.1 These test methods describe the determination of the specific gravity (relative density) and density of solid plastics in forms such as sheets, rods, tubes, or molded items.
1.2 Two test methods are described:
1.2.1 Test Method A—For testing solid plastics in water, and
1.2.2 Test Method B—For testing solid plastics in liquids other than water.
1.3 The values stated in SI units are to be regarded as the standard.
1.4 Warning—1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
Note 1: This standard is not equivalent to ISO 1183–1 Method A. This test method provides more guidelines on sample weight and dimension. ISO 1183-1 allows testing at an additional temperature of 27 ± 2°C.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
|2. Referenced Documents|
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
Latest update: 2022-12-07 (Number of items: 2 667 430)
© Copyright 2022 NORMSERVIS s.r.o.