Standard Specification for 100 Research Octane Number Test Fuel for Automotive Spark-Ignition EnginesTranslate name
STANDARD published on 1.1.2021
Designation standards: ASTM D8076-21
Publication date standards: 1.1.2021
The number of pages: 9
Approximate weight : 27 g (0.06 lbs)
Country: American technical standard
Category: Technical standards ASTM
alcohol, automotive fuel, automotive spark-ignition engine fuel, copper strip corrosion, corrosion, distillation, EPA regulations, ethanol, ether, fuel, gasoline, gasoline-alcohol blend, gasoline-ethanol blend, gasoline-ether blend, gasoline-oxygenate blend, high octane number fuel, induction period, lead, methanol, MTBE, octane number, octane number requirement, oxidation stability, oxygenate, oxygenate detection, solvent-washed gum, sulfur, unleaded fuel, vapor pressure, volatility,
1.1ï¿½This specification covers the requirements of a high octane number test fuel suitable for spark-ignition engines to be utilized in ground vehicles that will require 100 research octane number (RON) minimum rated fuel.
1.1.1ï¿½The fuels described by this specification are intended for developing technologies that lead to reduced vehicle energy consumption, such as higher compression ratio, higher power density, increased turbocharger boost pressure, smaller swept displacement volume, and operation at lower engine speeds.
1.1.2ï¿½The fuels described in this test fuel specification may not meet all of the performance or regulatory requirements for use in vehicles using commercial gasoline.
1.2ï¿½The fuels covered in this specification may contain oxygenates, such as alcohols and ethers, up to 50â€‰% by volume. This specification covers fuels that may contain both fossil and bio-derived components.
1.3ï¿½This specification provides a description of high RON test fuel for automotive spark-ignition engines that are not currently in the marketplace but are being developed and require a defined standard test fuel. The high RON fuel could become available in the marketplace if/when such engines are introduced in commerce. The specification is under continuous review, which can result in revisions based on changes in fuel, automotive requirements, or test methods, or a combination thereof. All users of this specification, therefore, should refer to the latest edition.
1.4ï¿½The values stated in SI units are the standard.
1.4.1ï¿½Exceptionâ€”Non-SI values are provided for information only. U.S. federal regulations frequently specify non-SI units.
1.5ï¿½This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6ï¿½This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
Latest update: 2021-04-19 (Number of items: 2 441 306)
© Copyright 2021 NORMSERVIS s.r.o.