Standard Test Method for Determining the Bulk Density of Solid Waste FractionsTranslate name
STANDARD published on 1.2.2019
Designation standards: ASTM E1109-19
Publication date standards: 1.2.2019
The number of pages: 3
Approximate weight : 9 g (0.02 lbs)
Country: American technical standard
Category: Technical standards ASTM
ICS Number Code 13.030.10 (Solid wastes)
|Significance and Use|
5.1 This test method describes a physical property of solid waste in processing facilities, a property that characterizes the solid waste streams and hence the operation of resource recovery separators and processors.
5.2 The bulk density is an important property for the design of materials handling equipment, separators, and processors.
5.3 In this test method, bulk density is not considered an absolute material property as is the density of individual particles of a material. The measured bulk density here depends on the size of the container, the moisture content of the “as tested” material, and how the material is loaded into the container. For example, the bulk density of material placed loosely in a container will be less than that of material tamped into a container. Also, some materials placed loosely in a container will settle with time due to its own weight; thus, its bulk density will increase. As written, the “as tested” waste sample may or may not be dried prior to testing, so that calculated bulk density includes the moisture associated with the “as tested” material.
1.1 This test method may be used to determine the bulk density of various fractions from the resource recovery processing of municipal solid waste. It is intended as a means of characterizing such fractions and for providing data useful to designers of solid waste processing plants.
1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
|2. Referenced Documents|
Do you want to be sure about the validity of used regulations?
We offer you a solution so that you could use valid and updated legislative regulations.
Would you like to get more information? Look at this page.
Latest update: 2021-04-11 (Number of items: 2 440 786)
© Copyright 2021 NORMSERVIS s.r.o.