We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
Standard Test Methods for Determination of Gold in Cyanide Solutions
Translate name
STANDARD published on 15.4.2023
Designation standards: ASTM E1600-23
Publication date standards: 15.4.2023
SKU: NS-1141907
The number of pages: 8
Approximate weight : 24 g (0.05 lbs)
Country: American technical standard
Category: Technical standards ASTM
Keywords:
cyanide solutions, flame atomic absorption spectrometry, gold concentration, inductively coupled plasma mass spectrometry,, ICS Number Code 73.060.99 (Other metalliferrous minerals)
Significance and Use | ||||||||||||||||||||||||||
4.1?In primary metallurgical processes for gold bearing ores, gold is extracted with an alkaline cyanide solution. Metallurgical accounting, process control, and ore evaluation procedures depend on accurate, precise, and prompt measurements of the gold levels. 4.2?These test methods are comparative referee methods for compliance with compositional specifications for metal amounts or to monitor processes. It is assumed that all who use these methods will be trained users capable of performing common laboratory procedures skillfully and safely. It is expected that work will be performed in a properly equipped laboratory under appropriate quality control practices such as those described in Guide E882, and that proper waste disposal procedures will be followed. |
||||||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||||||
1.1?These test methods cover the determination of gold in ore processing cyanide solutions within the following ranges:
Note 1:?The lower limit for the Inductively Coupled Plasma
Mass Spectrometry Method, 0.001 ?g/mL, was set following the
guidance of Practice E1601.
The reproducibility Index, R, was calculated using the total
standard deviation for the lowest concentration Youden pair
solution.
1.1.1?These test methods may also be applied to cyanide leach solutions from metallurgical evaluation procedures. 1.2?The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3?The test methods appear in the following order:
1.4?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||
|
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
Latest update: 2025-02-07 (Number of items: 2 224 292)
© Copyright 2025 NORMSERVIS s.r.o.