Cookies
We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
ASTM E1637-98
Standard Specification for Structural Standing Seam Aluminum Roof Panel Systems
STANDARD published on 10.9.1998
The information about the standard:
Designation standards: ASTM E1637-98
Note: WITHDRAWN
Publication date standards: 10.9.1998
SKU: NS-42462
The number of pages: 5
Approximate weight : 15 g (0.03 lbs)
Country: American technical standard
Category: Technical standards ASTM
Annotation of standard text ASTM E1637-98 :
Keywords:
Aluminum, Anchors/anchorage, Clips, Construction, Deflection, Endlaps, Environmental control/fate, Exposures, Fasteners, Flashings, Installation, Joints, Low-sloped roofs, Metals and metallic materials, Oil canning, Panels, Penetration, Ponding, Roofing membranes, Sealer, Service life, Side lap, Slope, Standing seam, Structural metals/alloys, Thermal, Uplift, Water, Waterproofing membranes, Weathertightness, structural standing seam aluminum roof panel systems, spec.,,Order Form
Additional information
| 1. Scope | ||||||||||||||||||||||||||||||||||||
|
1.1 This specification covers the design, construction, and weatherability of structural standing seam aluminum roof panel systems that resist all superimposed design loads without the benefit of supporting deck or sheathing. It includes performance requirements for the following elements only: panels, concealed panel clips, panel/clip anchorage, and panel joint sealers. 1.2 The objective of this specification is to provide for the overall performance of the standing seam aluminum roof panel system in accordance with 1.1 during its service life in order to provide weather protection, carry the specified design loads, and allow proper access over the roof surface in order to provide periodic maintenance of the equipment by the building owner. 1.3 In addition to structural characteristics, the specifier shall evaluate other characteristics beyond the scope of this specification that affect the final choice of roof construction. These include, but are not limited to, functional, legal, insurance, and economic considerations. See Appendix X1 for the designer's checklist. 1.4 This specification is not intended to exclude products or systems not covered by the referenced documents. 1.5 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. |
||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||
|
We recommend:
Updating of laws
Do you want to be sure about the validity of used regulations?
We offer you a solution so that you could use valid and updated legislative regulations.
Would you like to get more information? Look at this page.
