We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
Standard Test Method for Determining Particulate Matter Emissions from Fires in Wood-Burning Fireplaces
STANDARD published on 15.7.2013
Designation standards: ASTM E2558-13
Note: WITHDRAWN
Publication date standards: 15.7.2013
SKU: NS-45600
The number of pages: 18
Approximate weight : 54 g (0.12 lbs)
Country: American technical standard
Category: Technical standards ASTM
Keywords:
emissions, fireplaces, low-mass fireplace, particulate, particulate matter, wood-burning, ICS Number Code 13.040.40 (Stationary source emissions),97.100.30 (Solid fuel heaters)
Significance and Use | ||||||
5.1 This test method is used for determining emission factors and emission rates for low mass wood-burning fireplaces. 5.1.1 The emission factor is useful for determining emission performance during product development. 5.1.2 The emission factor is useful for the air quality regulatory community for determining compliance with emission performance limits. 5.1.3 The emission rate may be useful for the air quality regulatory community for determining impacts on air quality from fireplaces, but must be used with caution as use patterns must be factored into any prediction of atmospheric particulate matter impacts from fireplaces based on results from this method. 5.2 The reporting units are grams of particulate per kilogram of dry fuel and grams of particulate per hour. 5.2.1 Appropriate reporting units for comparing emissions from non-heating appliances: g/kg. 5.2.2 Appropriate reporting units for predicting atmospheric emission impacts only if hours of fireplace use are factored in: g/h. |
||||||
1. Scope | ||||||
1.1 This test method covers the fueling and operating protocol for determining particulate matter emissions from wood fires in low mass wood-burning fireplaces. The fueling and operating protocol for determining particular matter emissions from masonry or other high mass fireplaces is covered in 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||
2. Referenced Documents | ||||||
|
Historical
1.3.2011
Historical
1.4.2012
Historical
1.4.2013
Historical
15.7.2012
Historical
1.11.2011
Historical
1.8.2009
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
Latest update: 2024-03-25 (Number of items: 2 885 931)
© Copyright 2024 NORMSERVIS s.r.o.