We need your consent to use the individual data so that you can see information about your interests, among other things. Click "OK" to give your consent.
Standard Test Methods for Chemical Analysis of Cast Iron-All Types
STANDARD published on 1.6.2006
Designation standards: ASTM E351-93(2006)
Note: WITHDRAWN
Publication date standards: 1.6.2006
SKU: NS-46524
The number of pages: 49
Approximate weight : 147 g (0.32 lbs)
Country: American technical standard
Category: Technical standards ASTM
Keywords:
ICS Number Code 77.040.30 (Chemical analysis of metals)
Significance and Use | ||||||||||||||||||||||||||||
These test methods for the chemical analysis of metals and alloys are primarily intended as referee methods to test such materials for compliance with compositional specifications, particularly those under the jurisdiction of ASTM Committee A04 on Iron Castings. It is assumed that all who use these test methods will be trained analysts capable of performing common laboratory procedures skillfully and safely. It is expected that work will be performed in a properly equipped laboratory under appropriate quality control practices such as those described in Guide E 882. |
||||||||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||||||||
1.1 These test methods cover the chemical analysis of pig iron, gray cast iron (including alloy and austenitic), white cast iron, malleable cast iron, and ductile (nodular) iron having chemical compositions within the following limits: 1.2 The test methods in this standard are contained in the sections indicated below: 1.3 Procedures for the determination of several elements not included in these test methods can be found in Test Methods E 30 and Test Methods E 1019. 1.4 Some of the concentration ranges given in are too broad to be covered by a single method and therefore this standard contains multiple methods for some elements. The user must select the proper method by matching the information given in the Scope and Interference sections of each method with the composition of the alloy to be analyzed. 1.5 The values stated in SI units are to be regarded as standard. In some cases, exceptions allowed in Practice E 380 are also used. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards statements are given in Section and in special "Warning" paragraphs throughout these Methods. 1.6 This test method covers the determination of manganese in concentrations from 0.10 to 2.00 %. 1.7 This method covers the determination of phosphorus in concentrations from 0.02 to 0.90 %. |
||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||
|
Do you want to make sure you use only the valid technical standards?
We can offer you a solution which will provide you a monthly overview concerning the updating of standards which you use.
Would you like to know more? Look at this page.
Latest update: 2025-07-04 (Number of items: 2 207 347)
© Copyright 2025 NORMSERVIS s.r.o.